|
 |
 |
|
Back to Product Line |
|
|
|
|
|
|
Ultra-Light ... with an
Affordable Price |
|
Century 1624 - Designed as an
ultra light single axle towing
and recovery unit, the 1624
offers many standard features
found on more expensive units at
a very affordable price. The
body is constructed using
aluminum modular boxes to reduce
weight while still providing the
operator with 3 large
compartments for ample storage
space. The 3 stage underlift
with power tilt, gives you
12,000 lbs. of lift capacity at
a fully extended reach of
102.5". The 20 ton
non-extendable recovery boom is
equipped with a single 16,000
lb. winch that makes this a
truly versatile mid-range unit.
|
|
Note: Some optional
equipment may be shown. Other
Century Towing and Recovery
Equipment is available from your
local
Century Distributor.
|
|
|
CENTURY 1624 - STANDARD FEATURES |
|
138" CA Aluminum Modular Body with 3
Compartments Per Side |
|
96" Wide with Fenderettes |
7 Sets of Lift Forks |
|
175' x 1/2" Cable Assembly |
Single 16,000 lb. Winch |
|
360° Boom End Swivels |
Air Clutch Release |
|
Crossbar Sheave Attachment |
Spring Loaded Cable Storage Tie Back |
|
Manual Controls - Drivers & Passenger
Side |
Hydraulic Pump |
|
Mud Flaps |
8 Function Remote Hand Held Lanyard |
|
1 Set of 1/2" Hook Adapters |
Cable Tensioner |
|
1 Set of Safety Chains |
Light Pylon |
|
1 Pair of Spring Lift Adapters |
Spring Door Checks |
|
Tool Box Lights |
|
|
CENTURY 1624 - OPTIONAL EQUIPMENT |
|
Switch Panel |
Air Shift PTO |
|
Wrecker Special Light Bar |
Air & Electrical Hookups |
|
Additional Lifting Attachments |
In-Cab Controls |
|
Upper and Lower Work Lights |
6000 lb. L-Arms & Receivers |
|
Many other popular Century options |
|
|
CENTURY 1624 - SPECIAL FEATURES |
|
Significant weight forward for better
stability |
Simple to operate-no tricky mechanisms
to learn |
|
One winch and twin lift cylinders, built
for maximum stability and efficiency |
Efficiency, power, reach and reliability
standards among
industry's highest |
|
Automatic hydraulic lock on fold
cylinder-no complicated latch |
Top of sheave closer to the ground for
clearance under aerial lifts |
|
Boom lift power is continuous from
bottom to top: power remains constant
with any added height, seal reliability
is great with single stage lift
cylinders and there is power down for
all-weather flexibility |
Stinger tilt for the flexibility to lay
flat, yet control clearances by tilting
during lift |
|
Rear bumper closer to rear axle so load
can be
pulled in closer for better stability |
Proven Century 3-stage stinger crossbar |
|
CENTURY 1624 - SPECIFICATIONS
|
|
BOOM |
REACH / CAPACITY |
|
Lift Cylinders
Power Retracted 30° (TEMA)
Maximum Angle |
5" bore
40,000 lbs.
40° |
|
WINCH SPECIFICATIONS |
|
|
Single winch
Cable |
16,000 lbs.
175' x 1/2" (6 x 19) |
|
UNDERLIFT |
|
|
Full retracted to C.L. of Fork Holder
Fully extended to C.L. of Fork Holder
Wheel Lift capacity
Crossbar spread with L-Arms
Standard power tilt arc
Estimated shipping weight |
38" / 24,000 lbs.
102.5" / 12,000 lbs.
6,000 lbs.
93"
8°
6,500 lbs. |
|
CENTURY FORMULA III SERIES - CHASSIS
RECOMMENDATIONS |
|
The minimum RBM for each frame rail is
1,200,000 in./lb., the minimum GVW is
28,000 lbs., the minimum CA dimension is
138", and the minimum frame length
behind the center line of the rear axle
is 42 inches. The outside frame rails
of chassis extending behind cab must be
free of fuel tanks, air tanks, battery
boxes, etc.
Note: Specifications subject to
change without notice. All ratings
specified are based on structural
factors only, not
vehicle capacities or
capabilities.
|
